Connecting (Ac) The Inverter - Steca StecaGrid 8000 3ph Installations- Und Bedienungsanleitung

Protective earth
conductor
Neutral
Phase 3
conductor
Phase 1 Phase 2
EN

4.4 Connecting (AC) the inverter

Danger
Risk of death by electrocution!
When working on the solar power system, disconnect the inverter from the AC
X
power supply.
Turn the DC switch to off.
X
Make sure that the power supply cannot be unintentionally switched back on.
X
4.4.1 Connecting the inverter to the AC cable
1 Turn the DC switch to off.
2 Wire the AC connector:
 The connector layout is imprinted next to the contacts or can be found in
the adjacent drawing.
3 Close the connector:
Push the connector into the housing until it clicks into place.

Tighten the screw connection by hand.

4 To open the connector again, if necessary:
Loosen the screw connection.

Use a screwdriver to press the locking mechanism together at the point

shown and
push the connector out of the housing.

737.096 | 11.37
41