Switching On The Dc Supply - Steca coolcept Bedienungsanleitung

GB
Display characteristic curve
Finish
4.8

Switching on the DC supply

112
3. Press rs to change the value.
4. Press SET. The change is adopted.
5. Repeat steps 1 to 4 for the other parameters.
6. Press ESC. The check list is shown.
1. The previously set reactive power characteristic curve is dis-
played graphically (example in Fig. left).
2. Press ESC. The check list is shown.
✔ Finish has been selected in the check list and SET has been
pressed. One of 2 possible dialogues is displayed.
1. Proceed as follows, depending on the respective dialogue:
Dialogue Settings are incomplete: Press SET and
n
and work through the open items in the check list.
Dialogue Are all settings correct?:
n
Press ESC to correct settings or
Press and hold SET (> 1 s) to finish initial commis-
sioning.
2. If SET was pressed for a longer time then the inverter starts
anew and synchronises itself with the grid (Fig. left).
u Set the DC circuit breaker on the inverter to position I (Fig.
left). After testing via the internal MSD (approx. 2 minutes),
the power fed into the grid can be shown on the display
(assuming that sunlight is present).
———————————————————————————
Notice
The DC circuit breaker on the coolcept-x devices can be
secured with a padlock to prevent unintentional switch-on
(maximum padlock size of 7 mm).
———————————————————————————
747.431 | Z08 | 2014-01-31