Mounting The Inverter - Steca Grid 8000 Bedienungsanleitung

EN
8.2

Mounting the inverter

Fastening the mounting rail
3
4
2
Hanging the inverter on the mounting rail
2
58
1. Cover the upper ventilation holes of the inverter that lie be-
3
2
2. Fasten the mounting rail level on the mounting surface using
1
4
5
3
1
1. Hang the inverter  on the mounting rail  . Position the
2. Fasten the inverter to the mounting surface through the
Note
The procedure for removing the inverter from the mounting rail is
described in 8.10, p. 66.
6
low the mounting position (protection from drilling dust).
at least 2 stainless steel screws, as shown in the illustrations
at the left. Observe the following:
At least 2, or a maximum of 4, stainless steel screws are
–
required, depending on the load-bearing capacity of the
mounting surface.
Use screws and dowels etc. of a size appropriate for the
–
weight of the inverter.
The main part  of the mounting rail must lie flat on the
–
mounting surface  with the attachment area  for the
inverter casing facing upwards.
Caution
Danger of personal injury. The inverter weighs 42 kg.
• Always carry the inverter using at least two people.
• Use the handle  to carry the device.
Caution
Danger from hot surfaces. Allow hot inverters to cool
down before touching.
inverter so that the sheet metal tongue  slides into the cor-
responding recess on the mounting rail (between the mount-
ing areas for the casing).
fastening holes , using 2 suitable stainless steel screws and
dowels etc.
744.378 | 12.13