Connections - Yamaha CDR-HD1000 Bedienungsanleitung

PREPARATION

Connections

Turn off the power of this unit and the other components, and unplug them from the wall outlet before making any connections.
• Correctly connect the input and output jacks on this unit to the input and output jacks on the other components.
• Arrow marks (©) in the illustration below indicate the direction of the audio signal.
ANALOG LINE IN (REC)/
LINE OUT (PLAY) jacks
RCA pin cable
(included)
I Digital connections
• Remove the jack covers for the DIGITAL IN/OUT (OPTICAL) jacks before starting to make connections. Using the optical fiber cable,
connect the DIGITAL IN (OPTICAL) jack on this unit to the digital optical output jack on the other component, and the DIGITAL OUT
(OPTICAL) jack on this unit to the digital optical input jack on the other component.
• Keep the jack covers for future use. Replace them in order to protect the DIGITAL IN/OUT (OPTICAL) jacks from dust when the jacks
are not being used.
• When using the DIGITAL IN/OUT (COAXIAL) jacks, make connections with coaxial cables. Connect the DIGITAL IN (COAXIAL) jack
on this unit to the digital coaxial output jack on the other component, and the DIGITAL OUT (COAXIAL) jack on this unit to the digital
coaxial input jack on the other component.
I Analog connections
• Make sure to connect the L (left) and R (right) input and output jacks on this unit to the correct L (left) and R (right) input and output jacks
on the other component.
• Connect the ANALOG LINE IN (REC) jack on this unit to the analog output jack on the other component, and the ANALOG LINE OUT
(PLAY) jack on this unit to the analog input jack on the other component.
• The ANALOG LINE IN (REC)/LINE OUT (PLAY) jacks on this unit are numbered # and $ respectively. Connect these jacks to the
jacks with the same numbers when connecting this unit to a Yamaha amplifier or receiver.
I Plug in this unit to a wall outlet when all connections are complete.
Note
• When you play the data on the HDD or CDs, signals are output both from the ANALOG LINE OUT (PLAY) jack and from the DIGITAL
OUT (OPTICAL/COAXIAL) jacks.
6
E-
* This connector is used for an
examination in the factory.
RS–232C
ANALOG
LINE IN —LINE OUT IN
4 3
COAXIAL OPTICAL
L L
R R
REC PLAY
RCA pin cable
(included)
REC PLAY
L L
R R
OUT IN
Amplifier or receiver
DIGITAL IN/OUT (OPTICAL) jacks
DIGITAL IN/OUT (COAXIAL) jacks Coaxial cable (optional)
DIGITAL
OUT
COAXIAL OPTICAL
Optical fiber cable
(one included)
DIGITAL
INPUT
COAXIAL
OPTICAL
OPTICAL
DIGITAL
OUTPUT
To wall outlet
DIGITAL
OUTPUT
COAXIAL
DVD player or DAT deck