Portal Monitoring; Sending Config - Steca Grid 20000 Installationsanleitung

This address is required for communicating with the inverter via RS485
Note:
If you change this parameter (address) and wish to save it, you must restart the inverter!
The new address will only be active thereafter.
Protocol polling via Ethernet:
Input 1, 2 and 3
1: USS and RTP protocol
2: Solar data systems (old SolarLog
3: MeteoControl

6.4 Portal monitoring

Activation 0 or 1
0 = Portal monitoring not activ
1 = Portal monitoring activ

6.5 Sending Config

Activation 0 or 1
0 = no Config data in the waiting queue
1 = Config is sent.
748.508 | Z01 | 2013-06-10
©
firmware)

EN
45