Options; Power Plug; Radiation And Temperature Sensor - Steca Grid 20000 Installationsanleitung

EN
8

Options

8.1 Power Plug

Optionally, you can also order a larger connector housing with M32 cable gland that allows you to
connect a 5 x 10 mm² flexible power supply line.
Designation
VC-AL-T3-Z-M32-S-PLOMB

8.2 Radiation and temperature Sensor

A radiation and temperature sensor can be optionally connected for recording the solar radiation
incidence and the module temperature. We recommend using the type Si-13TC-T-K, Steca part no.
748297. The scope of delivery of the radiation and temperature sensor includes the sensor plug.
The sensor plug can also be separately ordered from Steca under part no. 748298.
The sensor comes with a 3 meter UV-resistant connecting line (5 x 0.14 mm²). The line can be
extended with a 5 x 0.25 mm² shielded line, max. 100m.
More information about the technical data of the sensor you will find in chapter 10 technical data
under 10.2.
Si-13TC-T-K pin assignment
Red RD Supply voltage (12–24 VDC)
Black BK GND
Orange OG Measurement signal for incident light (0–10 V)
Brown BN Measurement signal for temperature (0–10 V)
Gray GY Shielding
Note:
Figure No. 23
52
Steca part no.
748292
The shield of the sensor line must be applied to PIN 2 and PIN 5!
The outer diameter of the connecting cable can be max. 8 mm.
Connector M12 x 1 straight, shielded; pole arrangement: male M12, 5 pins,
A-coded, view of male connector side, Phoenix
5SC SH
Steca pin assignment: Sensor
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
: SACC-M12MS-
nomination
748.508 | Z01 | 2013-06-10