Steca Grid 20000 Installationsanleitung Seite 21

You should not open the device!
If this is not observed then dust, dirt and also humidity can penetrate or
components be damaged by an electro-static discharge and the degree
DANGER
of protection IP 65 is then no longer guaranteed.
There is subsequently no warranty for resulting damages!
Remark:
Any failure to observe these requirements may result in a malfunction
of the device or may even cause severe personal injuries through
crushing, shearing, cutting, striking, or fire!
CAUTION
When designing the attachment of the wall-mounting plate, take the weight of the inverter of 40 kg
into account.

Mounting the wall bracket: Use the wall bracket to mark the positions of the holes to be
drilled. Attach the mounting plate to the wall with the outer holes.

Insert the upper edge of the cooler into the recess of the device holder. Push the inverter
upwards until it stops and place the lower edge of the cooler onto the wall holder. En-
sure that the rib profile is locked behind the nuts. Finally secure the inverter in these nuts
using the enclosed screws (M5x20). As an alternative, you can also use a padlock
(shackle 4 mm in diameter) as anti-theft protection. The design of the wall bracket en-
sures that the inverter is automatically centered in this bracket.

To avoid adhesive residue on the inverter, we recommend to remove the display protec-
tor of inverter immediately after assembly from the display.
Avoid any load on the edge of the cover while mounting the device!
Do not use the cover to hold the device!
Only use the four holding grips to move the device!
CAUTION
748.508 | Z01 | 2013-06-10
While selecting the place of assembly, a free and unobstructed access for
servicing the inverter must be considered.
Otherwise the operator or installation engineer must provide suitable
technical auxiliary means for servicing.
EN
19