Disposal And Recycling; Troubleshooting; Troubleshooting Guide; Admitted Saw Chain And Chain Bar - Scheppach CSP2540 Originalbetriebsanleitung

12. Disposal and recycling

The unit is supplied in packaging to prevent its being damaged in transit. This packaging is raw material and can there-
fore be reused or can be returned to the raw material system.
The unit and its accessories are made of various types of material, such as metal and plastic. Defective components
must be disposed of as special waste. Ask about recycling in the store or in the local municipal administration!

13. Troubleshooting

Troubleshooting guide

Problem
Unit wonʼt start or starts but will
not run.
Der Motor startet, aber er läuft
nicht mit voller Leistung.
Engine hesitates.
No power under load.
Engine runs erratically.
Smokes excessively.
Poor performance when
operated
Engine dies
Insufficient chain lubrication
(the cutter rail and chain get hot)
14. Admitted saw chain and chain bar combination
saw chain
chain bar
48 І 76
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Probable cause
Incorrect starting procedures.
Incorrect carburetor mixture adjustment
setting.
Fouled spark plug.
Fuel filter plugged.
Dirty air filter.
Incorrect carburetor mixture adjustment
setting.
Incorrect carburetor mixture adjustment
setting.
Incorrectly gapped spark plug.
Incorrect carburetor mixture adjustment
setting.
Incorrect fuel mixture.
Blunt chain
Loose chain
Empty petrol tank
Fuel filter in the wrong position in the
tank
Empty oil tank for the chain
Oil lubrication openings moved
Oregon 91PX040X
Carlton N1C-BL-52E
Kangxin 3/8 LP-52
Oregon 100SDEA041
Kangxin AE14-53-509P
Corrective Action
Follow instructions in the user manual.
Have carburetor adjusted by an Authorized
Service Center.
Clean / gap or replace plug.
Replace fuel filter.
Remove, clean and reinstall filter.
Have carburetor adjusted by an Authorized
Service Center.
Have carburetor adjusted by an Authorized
Service Center.
Clean / gap or replace plug.
Have carburetor adjusted by an Authorized
Service Center.
Use properly mixed fuel (40:1 mixture).
Sharpen or replace the chain
Tension the chain
Fill up the petrol tank
Completely fill the petrol tank or or re-position
the fuel filter in the petrol tank
Top up the oil tank for the chain
Clean the oil lubrication hole in the cutter bar
Clean the groove in the cutter bar