Storage - Scheppach CSP2540 Originalbetriebsanleitung

General Chain saw
Saw chain
Chain brake
Guide bar
Before each start Saw chain
Guide bar
Chain lubrication
Chain brake
OFF switch,
Safety locking button,
Throttle lever
Fuel/ oil tank cup
Every day Air filter
Guide bar
Guide bar support
Idle speed
Every week Fan housing
Cylinder space
Spark plug
Muffler
Spark arrester screen
Chain catch sleeve
Screws and nuts
Every 3 months Fuel filter
Fuel, oil tank

Storage

Chain saw
Guide bar/ chain
Fuel, oil tank
Carburretor
11. Storage
Never put a chain saw into storage for longer than 30 days without carrying out the following steps.
Follow the cleaning instructions and maintenance instructions before storing the device!
Storage a chain saw
Storing a chain saw for longer than 30 days requires storage maintenance. Unless the storage instructions are followed,
fuel remaining in the carburetor will evaporate, leaving gum-like deposits. This could lead to difficult starting and result
in costly repairs.
Remove the fuel tank cap slowly to release any pressure in tank. Carefully drain the fuel tank.
Start the engine and let it run until the unit stops to remove fuel from carburetor.
Allow the engine to cool (approx. 5 minutes).
Remove the spark plug.
Pour 1 teaspoon of clean 2-cycle oil into the combustion chamber. Pull starter rope slowly several times to coat internal
components. Replace spark plug.
• Store the unit in a dry place and away from possible sources of ignition such as a furnace, gas hot water heater, gas
dryer, etc..
Puttig the saw back into operation
Remove spark plug.
Pull starter rope briskly to clear excess oil from combustion chamber.
Clean the spark plug and check that the electrode gap is correct.
Prepare unit for operation.
Fill fuel tank with proper fuel / oil mixture.
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Clean exterior, check for damage. In case of damage have
repaired by a qualified service center immediately
Sharpen regulary, replace in good time
Have inspected regularly at an authorized service center
Turn over to ensure even wear of bearing surfaces
Replace in good time
Inspect for damage and sharpness
Check chain tension
Check for damage
Functional check
Functional check
Functional check
Check for tightness and leckage
Clean
Check for damage, clean oil intake bore
Clean, in particular the oil guide groove
Check (chain must not run)
Clean to ensure proper air cooling
Clean
Check and replace if necessary
Check tightness of mounting
Clean
Check for damage, replace if necessary.
Check their condition and that they are firmly secured.
Replace
Clean
Clean exterior, check for damage. In case of damage, have
repaired by a qualified service center immediately
Demount, clean and oil slightly
Clean the guide groove of the guide bar
Empty and clean
Run empty
47 І 76