Resetting The Default Settings - G&D DP-Vision-Fiber Installationanleitung Und Betriebsanleitung

Resetting the default settings

NOTE: This function can be carried out only via web application.
This function is used to reset the default settings of the KVM extender. By perform-
ing this function, the default settings mentioned on page 21 are reactivated.
How to reset the default settings:
NOTE: Open the local OSD of the user module by pressing the
Alt + Num ) if you want to reset the local settings of the user module only instead of
the settings of the extender system.
1. Open the remote OSD of the computer module by pressing
(default: Ctrl +
Open the local OSD of the user module by pressing the
Alt + Num ) if you want to reset the local settings of the user module.
2. Select the row
(local OSD) and press
3. Select the row
4. Confirm the security prompt or cancel the process.
1. Click on the tools icon on the toolbar.
2. Click on the tabs
Use the information in the fields »Device« and »Comment« to check if you have selected
the right device.
3. If required, disable the option
the configuration of the network interfaces.
4. Click on Default settings
NOTE: You can also reset the default settings by pressing the Reset keys..
Further information about this topic is given on page 19.
Num ) if you want to reset the settings of the extender system.
System setup (remote OSD) or
Enter .
Set system defauts and press
Tools > Default settings
Delete network configuration
to reset the default settings.
local hotkey
local hotkey
Console utility
Enter .
.
if you want to keep
G&D DP-Vision-Fiber · 44
Configuration
(default:
remote hotkey
(default: