G&D DP-Vision-Fiber Installationanleitung Und Betriebsanleitung Seite 111

How to change the setting of the scancode set:
1. Press Ctrl+Num
2. Select the row
code set of the remote console (at the
Select the row
scancode set of the local console (at the
3. Under Scancode set
2  activates scancode set 2 for PS/2 keyboard inputs
3  activates scancode set 3 for PS/2 keyboard inputs
4. Press F2 to save your settings.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.
1. Click on
KVM Extenders > [All Extenders]
2. Double-click the computer module of the KVM extender you want to con-
figure.
3. Click on the tab
sole (at the CPU
Click on the tab
the remote console (at the
4. Under Scancode set
Set 2 activates scancode set 2 for PS/2 keyboard inputs
Set 3 activates scancode set 3 for PS/2 keyboard inputs
5. Click OK to save your changes.
6. Turn the KVM extender off and on again.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.
(default) to open the on-screen display.
and press
Console setup
Local console setup and press
press F8 to select one of the following options:
if you want to adjust the screensaver of the local con-
Local
module).
Remote > General if you want to adjust the scancode set of
CON module).
select one of the following options:
if you want to adjust the scan-
Enter
CON module).
Enter if you want to adjust the
CPU module).
on the directory tree.
G&D DP-Vision-Fiber · 40
Configuration