G&D DP-Vision-Fiber Installationanleitung Und Betriebsanleitung Seite 83

Connecting audio and RS232 interfaces
USB 2.0 Trans. RS232
Transmission DP Out
Micro In: If required, connect a microphone to this interface.
Connect the speakers or another audio output device.
Speaker:
RS232: Connect the serial end device to this interface.
Connecting further interfaces of ARU/ARU2 variants
USB 2.0 Trans. RS232
Transmission DP Out
USB 2.0 Devices: Use the two interface on the back and the two interfaces on the front
to connect USB devices.
NOTE: The USB 2.0 Devices
data rates:
variants: full speed
 ARU
variants: high speed
 ARU2
IMPORTANT:
Transmitting data of USB devices connected to the user module
between the user module and the computer module (and vice versa) requires trans-
mission modules that use laser technology and comply with laser class 1.
Please note the following safety instructions regarding this matter:
 Only use G&D certified transmission modules on page 2
USB 2.0 Trans.|Tx: When using an
cable connected to the USB 2.0 Trans.|Rx interface of the computer module.
USB 2.0 Trans.|Rx: When using an
cable connected to the USB 2.0 Trans.|Tx interface of the computer module.
Generic
USB 2.0 Devices
Micro In Speaker Keyb./Mouse
Generic
USB 2.0 Devices
Micro In Speaker Keyb./Mouse
interfaces of ARU and
ARU2 variant, insert the LC plug of the fibre optic
ARU2 variant, insert the LC plug of the fibre optic
Mouse
Keyb. Red. Power
Mouse
Keyb. Red. Power
ARU2 variants support different
G&D DP-Vision-Fiber · 12
Installation