Configuring Network Settings Manually - Auerswald COMfortel 3500 Inbetriebnahmeanweisungen

Commissioning
Tip: By tapping the entry field, you can fade in the Android keyboard on the
display. If you press the Back key, the Android keyboard will be faded out,
once more.
10.
Tap on OK.
11.
Tap on Default account (standard).
Hinweis: If SIPS/SRTP is switched on in the PBX, the system opens a
dialogue in which you enter the fingerprint. Enter the fingerprint, and then
tap on OK.
12.
Press the Home key to leave the setup assistant.
Further Steps
Configure the telephone according to your requirements. You can carry out
the configuration either via the display on the telephone (see the configura-
tion and operating manual) or via the integrated configuration manager
(recommended; see
If necessary, carry out a firmware update in order to extend the telephone
with the newly available functions (see
features is available on the support pages at the Auerswald website (Inter-
net address: www.auerswald.de).

Configuring Network Settings Manually

Requirements
– Message Faulty network setup which is shown on the display during com-
missioning
Steps to Take
1.
Tap on Faulty network setup.
2.
Tap on DHCP.
52
The telephone logs on to the PBX. If the registration is performed suc-
cessfully, a corresponding message will be displayed. The telephone is
now ready for use.
Page
The Settings > Network application will be opened.
DHCP is switched off.
COMfortel 3500 - Firmware Version 1.2B - Commissioning Instructions 02 07/12
59).
Page 32). Information about new