Assembly; Front Differential - Reely Ranger Bedienungsanleitung



7. Assembly

a) Front differential
The two differentials for front and back are the same apart from the drive axle for the motor (the rear differential holds
the main pinion for power transmission from the electric motor).
K1 (Ø10 x Ø15 x 4)
K2 (Ø5 x Ø11 x 4)
K3 (Ø5 x Ø10 x 4)
Take care to use the right bearings. The "K3" is slightly smaller and is intended for the rear differential.
The "A4" component is the actual bevel differential and is pre-mounted (the inner workings are shown in the figure
above).
K1
A3
S1 (10mm)
S2 (15mm), 4x
A1
A2
AC1
K2
Z1
SR1
ST1
A5
A4
K1
47