Safety Instructions; General Information; B) Assembly - Reely Ranger Bedienungsanleitung



5. Safety Instructions

In case of damage caused by not complying with these safety instructions the guarantee will be
rendered void. We will not assume any responsibility for consequential damage!
Nor do we assume liability for damage to property or personal injury caused by improper use or
the failure to observe the safety instructions! In such cases the guarantee will be rendered void.
Normal wear and tear during operation (e.g. worn tires) is excluded from the guarantee, the same
is the case for accidental damage (e.g. broken off suspension arm, scratched or destroyed car
body etc.).
Dear Customer, these safety instructions are not only for the protection of the product but also for your own
safety and that of other people. Therefore read this chapter very carefully before putting the product into
operation!
a) General information
Caution, important note!
Operating the model can lead to material and/or personal damage. Therefore, make sure that you are
properly insured when using the model, e.g. by taking out private liability insurance. If you already have
insurance, enquire whether the operation of the model is covered before operating it.
• The unauthorized conversion and/or modification of the product is prohibited for safety and approval reasons (CE).
• The product is not a toy and should be kept out of reach of children under 14 years of age.
• The product may not become damp or wet.
• Do not leave packaging material unattended. It may become a dangerous toy for children.
• Should questions arise that are not answered with the help of this operating manual, contact us (contact information
see chapter 1) or another expert.
The operation and the handling of remote control model cars must be learned! If you have never steered
such a vehicle, drive especially carefully and get used to the reactions of the car to the remote control
commands first. Do be patient!

b) Assembly

• There is a risk of injury through contact with sharp edges, pointed parts and incorrect use of tools when constructing
the vehicle.
• If the product is incorrectly constructed it can lead to damage to vehicle components and later on to poor driving
performance. Thus proceed with care when you assemble the product.
• Only construct the product on a suitably large, even, stable surface, protect the surface (i.e. of a work bench) from
scratches with a suitably thick covering or cloth.
• Do not use force during construction, do not excessively tighten the screws! Ensure however that screws and nuts
are correctly attached.
43