Werbung
Verfügbare Sprachen
Verfügbare Sprachen
* Do not operate the equipment near strong magnetic fields (motors, transformers etc.)
* Keep hot soldering irons or guns away from the equipment.
* Allow the equipment to stabilize at room temperature before taking up measurement (important for exact
measurements).
* Do not input values over the maximum range of each measurement to avoid damages of the meter.
* Use caution when working with voltages above 35V DC or 25V AC. These Voltages pose shock hazard.
* Periodically wipe the cabinet with a damp cloth and mid detergent. Do not use abrasives or solvents.
* The meter is suitable for indoor use only
* Do not operate the meter before the cabinet has been closed and screwed safely as terminal can carry
voltage.
* Do not store the meter in a place of explosive, inflammable substances.
* Do not modify the equipment in any way
* Do not place the equipment face-down on any table or work bench to prevent damaging the controls at
the front.
* Opening the equipment and service – and repair work must only be performed by qualified service
personnel
* -Measuring instruments don't belong to children hands-
Introduction of PeakTech
waveform generator
With Direct Digital Synthesis technique (DDS) and System On Programmable Chip technique (SOPC),
®
PeakTech
4035 and 4050 are of the excellent technical performance and powerful function characteristics
which are necessary for the fast measurement. TFT-LCD interface can show the illustration of output
waveform and parameters. Keypads and knob are convenient for operation. The introduction of
characteristics is following:
*
High frequency accuracy: up to 10
*
High frequency resolution: 9 digits or 1 µHz
*
Unlimited measurement range: digital setting directly for the whole range.
*
Non-intergraded process: up to the stable value immediately when switching, continuous signal
phase and amplitude without deflection.
*
High waveform accuracy: the output waveform consists of the computation value of functions with
higher waveform accuracy and less distortion.
*
Multi-waveform: 4 waveforms in common use, 5 built-in waveforms and 5 user- defined waveforms
can be output.
*
Pulse characteristics: variable edge time and accurate pulse width can be output.
*
Sweep characteristics: with the function of frequency sweeping and amplitude sweeping. Start point
and stop point can be set arbitrarily.
*
Modulation characteristics: FM, AM, PM, PWM and FSK modulation signal can be output.
*
Burst characteristics: the signal of burst count can be output.
*
Storage characteristics: 4 groups of user-defined parameters of generator state can be stored and
recalled at any moment.
®
4035 function generator and PeakTech
-5
.
-64-
®
4050 function / arbitrary
Werbung
