PeakTech 4035 Bedienungsanleitung Seite 118

MODULATION
CHARACTERISTICS
FM, AM, PM,
Modulation
Carrier Waveforms
Modulating Waveforms
Modulating Frequency
FM Frequency Offset
AM Modulating Depth
PM Phase Offset
PM Phase Delay
PWM Modulating Depth
FSK
Carrier Waveforms
Modulating Waveforms
FSK Rate
Hop Frequency
Internal Source
External Modulation Input
Input Impedance
Signal Range
Signal Frequency
BURST
Waveforms
Frequency
Burst Count
Start / Stop Phase
Period
Trigger Source
Continuous Burst
Single Burst
Gate Burst
SWEEP
Frequency/Amplitude
sweep
Carrier Waveforms
Frequency Range
Amplitude Range
Frequency Sweep Type
Amplitude Sweep Type
Direction
PWM
Sine, Square
Sine, Square
0° to 360°
0° to 360°
Sine, Square
40 mHz to 30M Hz
Only CH B as the burst output
signal
40 mHz – 1 MHz
1 – 65000 cycles
0°
Sine, Square
40mHz – 30 MHz
0 Vpp to 10 Vpp
Linear
Linear
Sine, Square, Ramp, Arb
(only PWM for Pulse)
Sine, Square, Triangle, Ramp
2 mHz to 20 kHz
1 μHz to 25 MHz
0.0% to 100.0%
0° to 360°
0° to 360°
0.0% to 99.0%
Sine, Square, Ramp, Arb
50% duty cycle square
2 m Hz to 100 kHz
1 μ Hz to 25M Hz
Internal Waveform, External
Signal
10 kΩ
± 5V full scale
DC to 20 kHz
Sine, Square, Ramp, Arb
1 μ Hz to 25M Hz
1 to 999.99 cycles
0° to 360°
1 μs to 500 s
Internal
Manual, External
Manual, External
Sine, Square, Ramp, Arb
1 μ Hz to 25M Hz
0 Vpp to 10 Vpp
Linear or Logarithmic
Linear
Up or Down
-117-