PeakTech 4035 Bedienungsanleitung Seite 105

Number color: you can set each of 5 changeable parameters' colors in the middle of the display interface,
the default colors are yellow.
Waveform color: set the color of wave of at the top of the display interface, the default color is red.
Option color: set the color of selected menu and option of the selected one, the default color is green.
Unit background: set the colors of 5 unit blocks on the bottom and 1 color block at the top right corner of the
display interface.
Menu background: set menu block's color on right of the display interface.
8.13.6 Remote address:
User can set remote address of this instrument. In the automatic measurement system formed by multi-
instruments, each instrument should have an exclusive address identification code.
8.13.7 Recall:
You can select the memory number to recall the specified instrument state which is determined by each
parameter's setting, just as frequency, amplitude, offset and so on. There are more than 30 parameters
totally named as instrument state. Select "Recall" and enter the storing number, then press yes key to recall
the specified state. Location 0# to recall the default setting, location 1# for power-on state, location 2#, 3#,
4# for user-defined state. Instrument will query whether you are sure to store before operation. Only press
the yes key to enable the operation.
8.13.8 State storing:
Press the 〖Recall〗 softkey to select the "store" option and set location number, you are able to store
current state to specified location. There are 5 non-volatile locations, which can store 5 instrument states
respectively and will not be lost even at powers off. Default state is stored in Location 0# which is can't be
stored in order to prevent default setting from breaking. Power-on state is stored in location 2# which the
state of common use should be stored in. It will be recalled when power on or system resetting. To avoid
covering the original data by intentional storing operation, instrument will query whether you are sure to
store before operation. Only press the yes key to enable the operation.
8.13.9 External store:
You can use U disk as external store. Connect U disk with "USB host" port on the front panel and "U" mark
will be shown on the low-left corner of screen. When storing the user-defined status of location 2#, 3#, 4#,
generator will ask you to check whether be sure to store into the U disk. Press 〖Yes〗key, generator will
create the corresponding file name STATE_2.set～STATE_4.set in U disk and data will be stored in. When
recalling the user-defined state of location 2#, 3#, 4#, and generator will ask you to check whether be sure to
recall the state in the U disk. Press〖Yes〗key to recall the state data stored in the corresponding file. If you
take wrong operation when storing or recalling, generator will give an alarm and operation will be invalid.
External store can make more operator store and use waveforms selected or modified by themselves. If
there is no USB Host on the front panel, no U mark will be shown at the low-left corner. When storing,
generator will ask you to check whether be sure to store into instrument and whether be sure to recall the
state when recalling. Operation for storing and recalling are both with internal store, but U disk store can't be
operated for 0# default state and 1# power-on state.
8.13.10 Reset:
Pressing〖Reset〗softkey can make generator back to state of power on.
-104-