Scheppach FPTS1500 Bedienungsanleitung Seite 20

FPTS1500
GB-
IE
Do not cut rebates or grooves without fitting a suitable guard, e.g. a
–
tunnel-type guard, over the saw table.
Circular saws must not be used for slotting jobs (cutting grooves which
–
end in the workpiece).
When transporting the electric tool, only use the transport devices.
–
Never use the protective devices for handling or transport.
Make sure that the lower part of the saw blade is covered during trans-
–
port, e.g. by the protective device.
Be sure to only use spacers and spindle rings specified by the manu-
–
facturer as suitable for the intended purpose.
The floor around the machine must be level, clean and free of loose
–
particles, such as chips and cutting residues.
Do not remove any cutting residues or other parts of workpieces from the
–
cutting zone while the machine is running and the saw unit is not at rest.
Support long workpieces (e.g. with a roller table) to prevent them sag-
–
ging at the end of a cut.
Warning! This electric tool generates an electromagnetic field during oper-
ation. This field can impair active or passive medical implants under certain
conditions. In order to prevent the risk of serious or deadly injuries, we recom-
mend that persons with medical implants consult with their physician and the
manufacturer of the medical implant prior to operating the electric tool.
SAFETY INSTRUCTIONS FOR THE HANDLING OF SAW BLADES
Only use insertion tools if you have mastered their use.
1
Observe the maximum speed. The maximum speed specified on the in-
2
sertion tool may not be exceeded. If specified, observe the speed range.
Observe the motor / saw blade direction of rotation.
3
Do not use any insertion tools with cracks. Sort out cracked insertion
4
tools. Repairs are not permitted.
Clean grease, oil and water off of the clamping surfaces.
5
Do not use any loose reducing rings or bushes for the reducing of holes
6
on saw blades.
Make sure that fixed reducer rings for securing the insertion tool have
7
the same diameter and have at least 1/3 of the cutting diameter.
Make sure that fixed reducer rings are parallel to each other.
8
Handle insertion tool with caution. They are ideally stored in the origi-
9
nally package or special containers. Wear protective gloves in order to
improve grip and to further reduce the risk of injury.
Prior to the use of insertion tools, make sure that all protective devices
10
are properly fastened.
Prior to use, make sure that the insertion tool meets the technical re-
11
quirements of this electric tool and is properly fastened.
Only use the supplied saw blade for cutting wood, never for the process-
12
ing of metals.
20
Safety