Troubleshooting; Faults With Display; Faults Without Display; Towing - Kärcher MIC 45 classic Originalbetriebsanleitung

Display Cause
Warning lamp for Engine is overheated
motor temperature
lights up
Warning lamp for Hydraulic oil overheated
hydraulic oil tem-
perature
Warning lamp for Battery is not being charged
battery lights up
Fault
Appliance cannot be started
Engine is running erratically
Engine is running but machine is
only moving slowly or is not mov-
ing at all
Operation problems with hydrau-
lic movement parts

Towing

Caution
Risk of damage. The machine may not be
towed. Do not move the machine at a
speed higher than walking speed.
Danger
The appliance is not approved for crane
loading.
 Fasten the towing rope to the towing
eye in the front or the rear.
 Slowly drag the appliance onto the
transport vehicle.
Caution
Risk of damage to the gear. Only push or
pull the appliance slowly.
30

Troubleshooting

Faults with display

Remedy
Set the engine speed to idle.
Clean the radiator (see "Care and Maintenance).
Run the engine in idle until the warning lamp turns
off.
Check the level of cooling liquid in the engine.
If the warning lamp does not turn off within 5 min-
utes, shut off the engine and contact Customer
Service.
Call Customer Service.

Faults without display

Remedy
Turn on the main switch.
Charging or replacing battery
Fill in fuel, deaerate the fuel system
Clean or replace fuel filter
Check fuel pipes, connections and joints and maintain them if required
Contact the authorised customer service.
Clean or replace air filter
Check fuel pipes, connections and joints and maintain them if required
Contact the authorised customer service.
Release parking brake
Pull the hand throttle lever all the way to the rear (MIC 45 advanced only)
Check level of hydraulic fuel
Contact the authorised customer service.
Contact the authorised customer service.
EN
13
-
By whom
Operator
Operator