Towing Hitch; Storage; Maintenance And Care; Maintenance Schedule . En - Kärcher MIC 45 classic Originalbetriebsanleitung

Towing hitch

The permissible drawbar and drawing
loads of the tractor are indicated in the
Chapter "Technical Specifications".

Storage

Warning
Risk of injury and damage! Note the weight
of the appliance in case of storage.
If the appliance is going to be out of service
for a longer time period, observe the follow-
ing points:
 Park the appliance in a safe, level and
dry place.
 Turn ignition key to "STOP" and remove
it.
 Switch off at main switch.
 Secure appliance to prevent it rolling
away, lock emergency brake.
 Change the engine oil and the oil filter
prior to extended storage.
 If frost is expected, check whether there
is enough anti-frosting agent in the
cooling water.
 Clean the inside and outside of the ma-
chine.
 Charge battery approx. every 2 months.

Maintenance and care

Maintenance schedule
Note
The elapsed-time counter shows the timing
of the maintenance intervals.
Daily before starting operations
 See chapter "Prior to start/safety test".
After the first 50 operating hours
Have the initial inspection performed by
Customer Service.
Change the engine oil and the oil filter.
–
Replace hydraulic oil.
–
Check cooler water level.
–
Check the V-belt and V-belt tension.
–
Every 100 operating hours
Change engine oil.
–
Lubricate the joints, machine holders
–
and cylinders (list of grease fittings, see
chapter "Lubricating machine").
Oil the ropes and joints.
–
Check cooler water level.
–
Check the hydraulic oil level.
–
Check battery.
–
Check whether all screw joints are tight;
–
tighten them, if necessary.
Check the V-belt and V-belt tension.
–
Check drum brake for function and set-
–
ting.
Check the hydraulic couplings for leaks.
–
Clean air filter.
–
Clean the radiator grill.
–
Every 200 operating hours
Change the motor oil filter.
–
Every 300 operating hours
Replace hydraulic oil filter.
–
26
Replace the ventilation filter on the hy-
–
draulic oil tank.
Every 600 operating hours
Replace hydraulic oil.
–
Replace the cooling liquid with frost pro-
–
tection.
Replace the fuel filter.
–
Every 800 operating hours
Check the valve gap and adjust it (done
–
by customer service).
Check the injector nozzles and clean
–
them (by Customer Service).
After each vehicle wash
 Grease the joint connection.

Maintenance Works

Important
In order to avoid operational problems, ut-
most cleanliness is vital for all check and
maintenance work.
 Park the machine on an even surface.
 Activate parking brake.
 Allow the machine sufficient time to cool
down before carrying out any mainte-
nance and repair work.
 Do not touch any hot parts, such as the
drive motor and exhaust system.
 Cooling water is hot.
 Lower the attachments to the ground or
secure them in the raised position.
 Secure the raised machine.
General notes on safety
Danger
Risk of injury due to engine overrun. Once
the engine has been switched off, wait for 5
seconds. Stay well clear of the working
area for this time.
When cleaning the appliance with a high
pressure cleaner, adhere to the respective
safety instructions.
Risk of injury if the machine is left running
in an unattended state. Remove the key
and disconnect the battery before working
on the appliance.
Do not point the high pressure jet towards
electrical components, tyres, radiator fins
and hydraulic hoses.
Maintenance on the hydraulic system must
only be carried out by trained personnel.
Never disassemble hydraulic hoses while
the machine is running.
Please do not release engine
oil, fuel oil, diesel and petrol
into the environment. Protect
the ground and dispose of
used oil in an environmentally-
clean manner.
Safety notes regarding the batteries
Please observe the following warning notes
when handling batteries:
Observe the directions on the
battery, in the instructions for
use and in the vehicle operat-
ing instructions!
9
-
EN
Wear an eye shield!
Keep away children from acid
and batteries!
Risk of explosion!
Fire, sparks, open light, and
smoking not allowed!
Danger of causticization!
First aid!
Warning note!
Disposal!
Do not throw the battery in the
dustbin!
Danger
Follow accident prevention regulations as
well as DIN VDE 0510, VDE 0105 T.1.
Risk of explosion! Do not put tools or similar
on the battery, i.e. on the terminal poles
and cell connectors.
Risk of injury! Ensure that wounds never
come into contact with lead. Always clean
your hands after having worked with batter-
ies.
Risk of fire and explosion!
Smoking and naked flames are strictly
–
prohibited.
Rooms where batteries are charged
–
must have good ventilation because
highly explosive gas is emitted during
charging.
Danger of causticization!
Rinse thoroughly with lots of clear water
–
if acid gets into the eye or comes in con-
tact with the skin.
Then consult a doctor immediately.
–
Wash off the acid If it comes in contact
–
with the clothes.