Next Level Racing F-GT Elite 160 Bedienungsanleitung Seite 8

support@nextlevelracing.com
)
A B
(REAR)
(FRONT)
03
A) Align the through holes on the Left and Right Base Members with the mounting holes on the Front Panel.
B) Bolt through with 4 x M8 Bolts and Washers.
04
Secure with 4 x M8 Flange Nuts.
) )
A B
05
A) Align the threaded holes on the Rear Base Member with the pre-drilled holes on the Left and Right Base Members.
B) Bolt through and secure with 6 x M8 Bolts and Washers.
PARTS:
• • 1 x Front Panel
)
• • 4 x M8 40mm Bolts
• • 4 x M8 Washers
PARTS:
• • 4 x M8 Flange Nuts
PARTS:
• • 1 x Rear Base
• • 6 x M8 45mm Bolts
• • 6 x M8 Washers
14
Note: Height of the foot can be adjusted only
06a
Install 4 x Adjustable feet into the T-Nuts previously installed in Step 01 and 02.
Note: Foot alignment tab
should sit in the channel.
06b
Align the tab on the NLR Height Adjustable Foot
with the extrusion channel.
(RIGHT)
07 A) Align the threaded holes on the Upright Connection Plates with the holes on the Vertical Posts.
B) Bolt through and secure with 8 x M8 Bolts and Washers.
Video Instruction: bit.ly/nlrbuild
PARTS:
when it's installed on to the cockpit.
• • 4 x Adjustable Feet
06c
Tighten the screw inside the NLR Height Adjustable
foot with an M8 Allen Key. Install Rubber Plug.
PARTS:
• • 2 x Vertical Posts (Left and Right)
(LEFT)
• • 2 x Upright Connection Plates
• • 8 x M8 35mm Bolts
• • 8 x M8 Washers
15