Next Level Racing F-GT Elite 160 Bedienungsanleitung Seite 11

support@nextlevelracing.com
Note: Do not tighten the
Pedal Plate until you have
your desired position.
20
Bolt through and secure with 8 x M8 Bolts and Washers.
PEDAL ADJUSTMENT RANGE
21 Loosen the Bolts on the Pedal Plates. Adjust to your desired position using the alignment lines and tighten the Bolts to lock in place. Loosen the
Bolts securing the Pedal Adjustment Fins to the Left and Right Base Frames and the Shoulder Bolts securing the Pedal Arms in order to adjust
angle. Loosen Bolts securing the Pedal Brackets to the Left and Right Vertical Posts to adjust Height. Tighten Bolts to lock in place.
) )
A B
( )
Buttkicker T-Nut Locations
A) Install 2 x T-Nuts into the bottom channel of the front Seat Slider Member for the Buttkicker Mount Pole. Install 2 x T-Nuts into the top channel
22
of both Seat Slider Members and slide to the marked locations. Attach Felt Pads to the bottom of the Seat Slider Members.
B) Align the holes on the Seat Slider Tabs with the threaded holes on the Seat Slider Members. Bolt through and secure with 4 x M8 Countersunk
Bolts.
20
PARTS:
• • 8 x M8 16mm Bolts
• • 8 x M8 Washers
23
PARTS:
• • NIL
24
PARTS:
• • 2 x Seat Slider Members
• • 6 x T-Nuts • • 4 x Seat Slider
Tabs
• • 4 x M8 16mm Countersunk Bolts
• • 4 x Felt Pads
(40mm x 35mm)
25
Align the mounting holes on the Seat Slider Tabs with the T-Nuts previously installed in Step 01 and
02.
Bolt through and secure with 4 x Seat Slider Ratchet Handles.
Align the mounting slots on the Seat Brackets with the T-Nuts previously installed in Step 22A.
21
Video Instruction: bit.ly/nlrbuild
PARTS:
• • NIL
PARTS:
• • 4 x Seat Slider Ratchet Handles
PARTS:
• • 2 x Seat Brackets