Next Level Racing F-GT Elite 160 Bedienungsanleitung Seite 13

support@nextlevelracing.com
SHIFTER ARM INSTALLATION
(MIRROR STEPS 32 TO 40 FOR RIGHT SIDE INSTALL)
)
A
32
A) Slide 1 x T-Nut into each outer channel of the Shifter Arm Support, and 2 x T-Nuts into the rear inner channel.
B) Align the Shifter Arm Plate with T-Nuts and Bolt through and secure with 2 x M8 Bolts and Washers.
33 Align the mounting holes on the Shifter Arm Plate with the T-Nuts previously installed in Step 01 (Step
02 for right side). Bolt through and secure with 2 x M8 Bolts and Washers.
34
Install 4 x T-Nuts into the outer channel of the Vertical Post. 1 x into the front channel, 2 x into the
centre channel and 1 x into the rear channel.
24
Note: For Direct Shifter PARTS:
Mount, skip to Step 48.
• • 1 x Shifter Arm Support
)
B
• • 1 x Shifter Arm Plate
• • 4 x T-Nuts
• • 2 x M8 20mm Bolts
• • 2 x M8 Washers
PARTS:
• • 2 x M8 20mm Bolts
• • 2 x M8 Washers
PARTS:
• • 4 x T-Nuts
)
A SAME ON OTHER SIDE B
(OUTER T-NUT LOCATIONS)
A) Install 2 x T-Nuts into the top channel of the Shifter Arm, 4 x into the bottom channel, 2 x into both upper channels and 2 x
35
into the outer lower channel.
B) Align the mounting holes on the Shifter Arm Bracket with the T-Nuts. Bolt through and secure with 6 x M8 Bolts and Washers.
36 Align the mounting holes on the Shifter Arm Brackets with the T-Nuts previously installed in Steps 32
and 34.
37
Bolt through and secure with 6 x M8 Bolts and Washers.
25
Video Instruction: bit.ly/nlrbuild
PARTS:
) • • 1 x Shifter Arm
• • 3 x Shifter Arm Brackets
• • 6 x M8 16mm Bolts
• • 6 x M8 Washers
• • 12 x T-Nuts
PARTS:
• • NIL
PARTS:
• • 6 x M8 16mm Bolts
• • 6 x M8 Washers