Next Level Racing F-GT Elite 160 Bedienungsanleitung Seite 24

support@nextlevelracing.com
A)
B)
91
A) Align the Front Traction Base Member's threaded holes with the through holes on the Left and Right Base Members (Circled).
B) Bolt through and secure with 4 x M8 Bolts and Washers.
A)
B)
92
A) Align the mounting holes on the Front Panel with the through holes on the Left and Right Base Members (Circled).
B) Bolt through and secure with 4 x M8 Bolts, Washers and Flange Nuts.
A)
93
A) Uninstall 6 x M8 Bolts and Washers securing the Rear Base Member to the Left and Right Base Members.
B) Remove the Rear Base Member.
46
PARTS:
• • 1 x Front Traction Base Member
• • 4 x M8 45mm Bolts (Included with
Elite Motion Kit)
• • 4 x M8 Washers
PARTS:
• • 4 x M8 40mm Bolts
• • 4 x M8 Washers
• • 4 x M8 Flange Nuts
PARTS:
B)
• • NIL
94 Install 4 x T-Nuts into the outer lower channel of the Rear Base Member and slide to the marked
locations.
A)
95
A) Align the threaded holes on the Rear Base Member with the through holes on the Left and Right Base Members (Circled).
B) Bolt through and secure with 6 x M8 Bolts and Washers.
B)
A)
96 A) Align the through holes on the Rear Traction Base Member with the T-Nuts previously installed in Step 94. Bolt through and
secure with 4 x M8 Bolts and Washers.
B) Install 2 x End Caps (Hardware included with Elite Motion Kit).
47
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 1 x Rear Base Member
• • 4 x T-Nuts
Note: For easier installation hand
screw M8 Bolt in to T-Nut to assist
sliding T-Nut in to channel.
PARTS:
• • 6 x M8 45mm Bolts
B)
• • 6 x M8 Washers
PARTS:
• • 1 x Rear Traction Base Member
• • 4 x M8 45mm Bolts
• • 4 x M8 Washers
Repeat
• • 2 x End Caps (40 x 80 Left and
on Other
Right)
Side