Next Level Racing F-GT Elite 160 Bedienungsanleitung Seite 19

support@nextlevelracing.com
NOTE: Leave the Seat Slider
Members aside for future steps.
67 Uninstall the Countersunk Bolts securing the Seat Slider Tabs to the Seat Slider Members and remove
the Seat Slider Tabs.
)
B
)
A
)
C
A) Uninstall the End Caps at the rear of the Left and Right Base Members. Uninstall the upper Bolts and Washers that secure the
68
Left and Right Base Members to the Rear Base Member.
B) Uninstall 2 x T-Nuts from the upper outside channels of each Base Member where the Ratchet Handles were installed.
C) Install 2 x T-Nuts into the top channels of each Base Member uninstalled in Step B).
A)
NOTE: Leave Bolts finger tight to
allow adjustments in future steps.
69
Align the mounting slots on the Seat Brackets with the T-Nuts previously installed in
STEP 68. Bolt through and secure with 4 x M8 Bolts and Washers.
36
PARTS:
• • NIL
PARTS:
• • NIL
PARTS:
• • 2 x Seat Brackets
B)
• • 4 x M8 16mm Bolts
• • 4 x M8 Washers
A)
Repeat
on all
corners
70
A) Align the Seat Sliders mounting holes, with the T-Nuts in the Seat Slider Members uninstalled in STEP 66.
B) Bolt through and secure with 4 x M8 Low-Profile Bolts included with the Seat.
71 Align the threaded holes on the end of the Seat Slider Members with the mounting holes on the Seat
Brackets.
72
Bolt through and secure with 2 x Shoulder Bolts, M8 Bolts, and M8 Washers.
37
Video Instruction: bit.ly/nlrbuild
PARTS:
B)
• • 4 x M8 16mm Low-Profile Bolts
(Included with Bottom Mount Seats)
• • 2 x Seat Slider Members
(Previously uninstalled in Step 67)
PARTS:
• • NIL
PARTS:
• • 2 x Shoulder Bolts
• • 2 x M8 16mm Bolts
Repeat
on Other
Side
• • 2 x M8 Washers