Lohmann & Rauscher Suprasorb CNP P3 Gebrauchsanweisung Seite 136

Using the power socket on the Suprasorb
power supply for charging or operation via the power supply provided.
Incorrect voltage power supply
Improper operation causes overvoltages to develop in the device which can then pass
to the user.
• Ensure that the power supply is set to a voltage of 100-240 V alternating current
prior to use.
• Only operate the device with one of the following power supplies:
PLEASE NOTE
· TR15RAM150-E-160E24 Input 15 V DC 1 A
· FW8001M15 Input 15 V DC 1.2 A
If required, there is an adapter supplied in the case with which the device can be
connected up to the mains power supply in your country.
Use the supplied power supply only.
Start by connecting the power supply to the power socket on the Suprasorb
unit. Then connect the power supply to the mains power supply.
Exudate pouch tube
Container system
(container & exudate pouch)
CNP P3 therapy unit, connect the unit to the mains
®
Device
for generation of negative
pressure
Power cable
Power supply
for the Suprasorb CNP P3
®
therapy unit
Socket
Wound drainage system
Connecting the
Suprasorb
therapy unit with connected
container system to the
patient and accessories
CNP P3 therapy
®
Patient
CNP P3
®