HMS ABS MASTER PRO SUPER Gebrauchsanweisung Seite 6

After training
Removing the device
• Correct: grasp the end of the belt and gently remove it from top to bottom.
• Incorrect: do not pull too hard or pull on small parts – this may damage the pads. After use,
place the belt on the protective film and store it in the bag to protect the gel pads.
Maintenance
1. Wipe off sweat and moisture with a dry cloth.
2. For stains, use a soft cloth dampened with warm water and a neutral detergent.
3. Then wipe with clean water and dry.
4. Dry in a natural, shaded and well-ventilated place.
Replacing gel pads
1. Remove the blue film (front).
2. Place the pad on the silver electrode.
3. Remove the transparent film from the back of the pad (back).
Note: Remove the foil gently – excessive force may damage the pad. Do not use damaged, dirty or worn pads.
Troubleshooting
Status
No stimulation
Stimulation too low
Stimulation too strong
Sudden interruption in stimulation
The cap is not sticky
Redness, pinching
If the problem persists despite following the above instructions, please contact your retailer.
Possible cause
Device switched off
The cover does not fit
The cover is damaged
The cover is dirty
Low intensity level
Low device power
Level too high
The cap does not fit properly
Battery discharged
Dirty or damaged
The cap does not fit
Cap is dirty or dry
Cap damaged
6
Solution
Press "+"
Adjust to the skin
Replace
Replace
Increase "+"
Recharge
Decrease intensity
Adjust
Recharge
Replace
Adjust
Replace
Replace
EN