Fronius RI IO PRO/i Bedienungsanleitung Seite 49

Connector X6:
Pin Type of signal
1 digital Input
2 digital Input
3 analog Input
4 digital Input
5
digital Input
6 digital Input
7 -
8 digital Output
9 -
10 digital Output
11 analog Input
Connector X7:
Pin Type of signal
1 -
2 -
3 analog Output
4
digital Input
5 digital Input
6 digital Input
7 digital Input
8 digital Input
9 -
10 -
11 analog Output
12 digital Input
13
digital Input
14 digital Input
15 digital Input
16 digital Input
Signal
Supply Voltage +24 V
Welding simulation
For the MIG/MAG welding process:
Pulse-/dynamic correction command value
For the TIG welding process:
vD correction
GND for digital Inputs
Torch blow out
Wire backward
-
Supply Voltage +24 V
-
Limit signal = factory assignment
Torch body gripped = on the website of the welding
machine, the pin can also be assigned this signal if
desired
GND for X6/3
Signal
-
-
For the MIG/MAG welding process:
Actual real value for seam tracking
For the TIG welding process:
Actual real value AVC
Working mode, Bit 3
Working mode, Bit 4
Welding characteristic- / Job number, Bit 8
Welding characteristic- / Job number, Bit 9
Welding characteristic- / Job number, Bit 10
-
-
GND for X7/3
Welding characteristic- / Job number, Bit 11
Welding characteristic- / Job number, Bit 12
Welding characteristic- / Job number, Bit 13
Welding characteristic- / Job number, Bit 14
Welding characteristic- / Job number, Bit 15
Englisch (US)
49