Fronius RI IO PRO/i Bedienungsanleitung Seite 34

(1)
34
2
3
4
5
6
7
(2)
Check the position of the jumper
on the interface – standard
mode/OC mode
Connect the cable harness (2) to
the robot control
Connect the cable harness (2) to
the interface as shown
Connect the cable harness (1) to
the interface as shown
Connect the cable harness (1) to
the SpeedNet connection cable of
the welding machine
Connect the SpeedNet connection
cable to the SpeedNet connection
on the rear of the welding machine