Changing/Assigning Characteristic Numbers/Program Numbers (Retro Fit Mode) - Fronius Ri Io Pro/I Bedienungsanleitung

Available range for job numbers:
-
-
Available range for characteristic numbers:
-
-
NOTE!
Characteristic / job number "0" enables a characteristic / job to be selected
on the welding machine control panel.
Changing/ For welding machines in the TPS series, the material, the wire diameter, and the
assigning cha- protective gas shield can be selected using the program number. A bit width of 8
racteristic num- bits was defined for this.
bers/program It is possible to assign a program number to a characteristic number (1-255) so
numbers (Retro
that the 8-bit signal can be used in retrofit mode.
Fit mode)
Note down the IP address of the welding machine being used:
1
Access website of the welding machine in the internet browser:
6
38
Bit numbers 0-15 = 0 - 1000
Bit numbers 0-7 (Retrofit) = 0 - 255
Bit numbers 0-15 = 256 - 65535
Bit numbers 0-7 (Retrofit) = 0 - 255 When using Retrofit mode, the IDs of
the desired characteristics must be assigned to the respective characteris-
tic numbers (1 - 255), otherwise it is not possible to select the characteristic
via the interface – see
program numbers (Retro Fit mode)
Connect the welding machine to the computer (for example using a LAN ca-
ble)
Pulse 4-step
3
1
Pulse 4-step
xx.x.xxx.x
xx:xx:xx:xx:xx:xx
Enter the IP address of the welding machine in the search bar of the internet
browser and confirm
- The website of the welding machine is displayed
Changing/assigning characteristic numbers/
on page 38.
Select "Defaults" in the left sidebar
2
of the welding machine control pa-
nel
Select "System" in the right side-
3
bar of the welding machine control
panel
2
Press the "Information" button on
4
the welding machine control panel
Note down the displayed IP ad-
5
dress (example: 10.5.72.13)
4