Fronius RI IO PRO/i Bedienungsanleitung Seite 47

Connector X3:
Pin Type of signal
1 analog Input
2 analog Input
3
digital Input
4 analog Output
5
6
analog Output
7 analog Output
8 analog Input
9
10 digital Input
11 analog Output
12
13 analog Output
14
analog Output
15 digital Output
16 digital Output
Signal
Wire retract correction command value
For the MIG/MAG welding process:
Wire forward / backward length
For the TIG welding process:
Plasma gas command value
GND for digital Inputs
Welding voltage
-
Wire feed speed
Motor current M1 = factory assignment
Motor current M2, M3 = on the website of the wel-
ding machine, the pin can also be assigned this si-
gnal if desired
GND for X3/1
-
GND for digital Inputs
GND for X3/4
-
GND for X3/6
GND for X3/7
Touch signal
Current flow = factory assignment
Robot motion release / Process run = on the website
of the welding machine, the pin can also be assigned
this signal if desired
Englisch (US)
47