Charging Process; Unplug Charger From Battery - Fazua Ride 60 Originalbetriebsanleitung

Original instructiOns | English
2. Insert the charging plug [C.8] into the charging connection [C.1] on the battery.
C.1
3. Insert the mains plug [C.9] into a suitable wall outlet to establish the power
connection.

28.3 Charging process

The charging process begins as soon as you have connected the charger to the
e-bike or battery on one side and to the power supply on the other.
The flashing LEDs on the battery charge indicator indicate that the battery is being
charged.*
During the charging process, the LED indicator [C.7] on the mains adapter lights
up red to indicate that the battery is charging.
When the colour of the LED indicator [C.7] switches to green, this indicates that
the battery is fully charged.

28.4 Unplug charger from battery

1. When charging is complete, unplug the mains plug [C.9] from the outlet to
disconnect the charger from the mains.
2. Then disconnect the charger from the e-bike/battery by pulling the charging
plug [C.8] out of the charging socket [C.5] on the e-bike or out of the charging
connection [C.1] on the battery.
IMPORTANT: Close the cover flap of the charging socket again after the charging
process and ensure that the charging socket is correctly closed.
3. If necessary, reinsert the battery into the e-bike.**
4. Then disconnect the mains cable [C.9] from the mains adapter [C.6] and keep
the two parts separate.
* Applies only to removable batteries, not to permanently installed batteries.
** Applies only to removable batteries, not to permanently installed batteries.
C.8
45