Using "Push Assist" Mode; Switching The Bicycle Lighting On And Off; Bluetooth® Connection - Fazua Ride 60 Originalbetriebsanleitung

21.5.2 Using "Push Assist" mode

1. Set the assistance level to "none".
2. Press and hold the control switch [B.2] towards
the centre of the handlebar to use the push assist.
After 2 seconds, push assist is activated and sets
the e-bike in motion as long as you keep the control
switch pressed.
3. Guide the e-bike with both hands and brake as
necessary to adjust the speed of the e-bike to
your own walking pace by holding or restraining
the e-bike while pushing.
4. Switch off the push assist by releasing the control
switch.

21.6 Switching the bicycle lighting on and off

This function depends on the model
and is only available when a bicycle
light is connected.
Press the control switch [B.1] 1× briefly towards
→
the center of the handlebar to switch on the bike
lights.
Press the control switch [B.1] again 1× briefly
→
towards the center of the handlebar to switch the
bike lights off again.
21.7 Bluetooth® connection
You can connect your mobile phone to your drive system via the FAZUA App. Once
the connection has been successfully established, the five LEDs of the LED display
[B.2] flash blue 3 times.
→ For more information on the FAZUA App, see in chapter 5 "FAZUA App".
32
English | Original instructiOns
Control Hub
Ring Control
1×
Control Hub
1×
Ring Control