Current Charge Level And Set Assistance Level; Using The Control Element - Fazua Ride 60 Originalbetriebsanleitung

Original instructiOns | English
Possible status displays
• The upper LED flashes green = "Ready for operation"
After successful installation of the battery in the e-bike, the status indicator
flashes green briefly to indicate that you can now switch on the drive system

using the control element.

• The upper LED flashes yellow = "Soft Fault
If a "Soft Fault" occurs, the status display flashes yellow. In this way, the drive
system indicates that there is a temporary or non-critical fault that in most
cases will result in reduced performance.
If a "Soft Fault" occurs, you will be able to continue riding your e-bike, but
FAZUA strongly recommends not doing so to avoid further faults or damage to
the drive system or to the e-bike.
• The upper LED flashes red = "Hard Fault"
When a "Hard Fault" occurs, the status display flashes red. If a "Hard Fault"
occurs on your e-bike, the e-bike can no longer be used and requires mainte-
nance.

20.2 Current charge level and set assistance level

All five LEDs of the LED display [B.2] together indicate two parameters.
1. The battery charge level indicator:
The charge level of the battery can be read from the number of illuminated
LEDs. Each of the 5 LEDs here represents 20 % of the total charging capacity.
When the battery is fully charged, all 5 LEDs light up. If the battery is flat, the
upper LED of the status indicator lights up white or no LED lights up.
2. The selected assistance level of the pedal assist:
Each assistance level is assigned a colour, i.e. You can read off the assistance
level currently set via the colour of the lit LEDs on the display.
→
More detailed information can be found in chapter 21.3 "Assistance levels".'
27