Setting The Set Points; Setting The Cabinet Temperature Set Point; Setting The Product Temperature Set Point; Setting The Cycle Duration - Tefcold Blc3Ax1 Benutzerhandbuch

EVCO S.p.A.

7.5 Setting the set points

7.5.1

Setting the cabinet temperature set point

When selecting a continuous or customized blast chilling or blast-freezing cycle, the pre-set cabinet temperature, product
temperature, time and fan speed values when the parameters were set are loaded. These can be modified by the user
within the permitted range for the parameters. To make a modification press the
The screen shown below will appear and the editable value will become orange.
Set the desired value using the
return to the previous screen.
7.5.2

Setting the product temperature set point

Proceed as described for the cabinet set point, after pressing area
indicated by the needle probe).
7.5.3

Setting the cycle duration

Proceed as described for the cabinet set point, after pressing area
7.5.4

Setting the fan speed

Proceed as described for the cabinet set point, after pressing area
The minimum fan speed value that can be set for all cycles (except for slow cooking) is given by parameter F53.
The minimum fan speed value that can be set for slow cooking is given by parameter F54.
Vcolor 869/879 | Installer manual ver. 4.0 | Code 144VC869E404
key. Once set-up is complete press the
for the product temperature (or the temperature
for the cycle duration.
for the fan speed.
page 33 of 96
key next to the value to be edited.
next to the edited value and