Tefcold BLC3AX1 Benutzerhandbuch Seite 262

EVCO S.p.A.
i11 0
i12 5
i13 -
PAR. DEFAULT
u01c 1
u02c 3
u03c 4
u04c 5
u05c 6
u06c 7
u07c 8
u08c 9
u09c 10
u10c 13
u11c 14
0 1 - - - -
-1 240 s
- - - - - -
MIN. MAX. U.M.
0 12 - - - -
0 12 - - - -
0 12 - - - -
0 12 - - - -
0 12 - - - -
0 12 - - - -
0 12 - - - -
0 12 - - - -
0 12 - - - -
0 15 - - - -
0 15 - - - -
Vcolor 869/879 | Installer manual ver. 4.0 | Code 144VC869E404
Thermal switch input polarity
0 = normally open (input active with contact closed)
1 = normally closed (input active with contact open)
Thermal switch alarm signal delay
-1 = alarm not signalled
unused
DIGITAL OUTPUTS
Function managed by output K1
0. Unused
1. Compressor 1
2. Compressor 2
3. Defrost
4. Evaporator fan
5. Condenser fan
6. Door heater
7. Thawing heater
8. Alarm
9. Pump down valve
10. Needle probe heater
11. UV lamp
12. Cabinet light
13. Cabinet heater (only for relays from u10c to u13c)
14. Steam Generator (only for relays from da u10c to u13c)
15. Steam injection (only for relays from u10c to u13c)
Function managed by output K2
Same settings as specified under parameter u01c
Function managed by output K3
Same settings as specified under parameter u01c
Function managed by output K4
Same settings as specified under parameter u01c
Function managed by output K5
Same settings as specified under parameter u01c
Function managed by output K6
Same settings as specified under parameter u01c
Function managed by output K7
Same settings as specified under parameter u01c
Function managed by output K8
Same settings as specified under parameter u01c
Function managed by output K9
Same settings as specified under parameter u01c
Function managed by output K10 (if the expansion is present)
Same settings as specified under parameter u01c
Function managed by output K11 (if the expansion is present)
Same settings as specified under parameter u01c
page 79 of 96