Tefcold BLC3AX1 Benutzerhandbuch Seite 258

EVCO S.p.A.
d2 2
d3 30
d4 0
d5 30
d7 2
d15 0
d16 0
PAR. DEFAULT
A1 10
A2 1
A4 10
A5 1
A7 15
(1)
-50 99 °C/°F
0 99 min
0 1 - - - -
0 99 min
0 15 min
0 99 min
0 99 min
MIN. MAX. U.M.
(1)
0 99 °C/°F
0 1 - - - -
(1)
0 99 °C/°F
0 1 - - - -
0 240 min
Vcolor 869/879 | Installer manual ver. 4.0 | Code 144VC869E404
is switched on, regardless of the door status, or
regardless of the status of the door switch input)
3 = air with the
compressor is switched off and the defrost output is
activated. The evaporator fan is switched on, provided
the door is open or provided the door switch input is on
and that parameter i0 is set to a value other than 0).
Evaporator temperature to end defrosting. See also parameter
d3
If the evaporator probe is not present (P4=0), it sets the
defrost duration.
If the evaporator probe is present (P4=1), it sets the
maximum defrost duration. See also parameter d2
0 = defrost is never activated.
Enable defrost at the start of blast chilling and of blast-freezing
0 = no
1 = yes
Defrost delay from the beginning of conservation
0 = defrost will be activated once the time set by d0 has
elapsed.
Drip time after a defrost, in which the compressor and the
evaporator fan are switched off and the defrost output is
deactivated.
Minimum consecutive compressor-on duration for starting hot
gas defrost, if d1 is set to 1
Pre-drip time if d1 is set to 1 (hot gas defrost), in which the
compressor and the evaporator fan are off and the defrost
output remains activate.
TEMPERATURE ALARMS
Cabinet temperature below which the minimum temperature
alarm is activated (in relation to the working set point, i.e.
"r10–A1" during conservation after blast chilling and "r11–A1"
during conservation
TEMPERATURE" code). See also parameter A11
Enable minimum temperature alarm ("LOW TEMPERATURE"
code):
0 = no
1 = yes
Cabinet temperature above which the maximum temperature
alarm is activated (relating to the working set point, i.e.
"r10+A4" during conservation
"r11+A4" during conservation after blast-freezing ("HIGH
TEMPERATURE" code). See also parameter A11 (4)
Enable maximum
TEMPERATURE" code):
0 = no
1 = yes
Temperature alarm delay ("HIGH TEMPERATURE" code and
"LOW TEMPERATURE" code)
page 75 of 96
door open (during defrosting
after blast-freezing;
after blast chilling and
temperature alarm
the
("LOW
("HIGH