Tefcold BLC3AX1 Benutzerhandbuch Seite 260

EVCO S.p.A.
F33 1
F34 1
F35 5
F36 5
F37 5
F38 5
F39 5
F40 5
F41 5
F42 5
F43 5
F44 5
F45 5
F46 15
F47 30
F48 ---
F49 0
F50 0
F51 180
F52 60
F53 1
F54 1
F55 20
Vcolor 869/879 | Installer manual ver. 4.0 | Code 144VC869E404
1 5 - - - -
1 5 - - - -
1 5 - - - -
1 5 - - - -
1 5 - - - -
1 5 - - - -
1 5 - - - -
1 5 - - - -
1 5 - - - -
1 5 - - - -
1 5 - - - -
1 5
1 5
(1)
0 99 °C/°F
0 240 s
0 1 0
0 1 ---
0 1 ---
0 999 s
0 999 s
1 5 ---
1 5 ---
0 100 %
Fan speed in fifth thawing phase.
Fan speed during conservation after thawing.
Fan speed in first sanitation phase (blast chilling).
Fan speed in second sanitation phase (holding).
Fan speed in third sanitation phase (conservation).
Fan speed during customized blast chilling.
Fan speed during customized conservation.
Fan speed during slow cooking.
Fan speed during holding after slow cooking.
Fan speed during blast chilling (for proofing cycle)
Fan speed during re-awakening.
Fan speed during proofing.
Fan speed during conservation (for proofing cycle)
Condenser temperature above which the condenser fan
switches on.
Condenser fan switch-off delay from when the compressor is
switched off (only if the condenser probe is not present).
Condenser fan status during defrosting.
0 = off
1 = on
Fan operating mode during conservation
0 = parallel to the compressor
1 = always ON
Fan operating mode during slow cooking
0 = always ON
1 = ON if heating elements are ON, with ON-OFF cycles if
heating elements are OFF
Fan OFF time during heating when operating with F50 = 1
Fan ON time during heating when operating with F50 = 1
Minimum fan speed that can be set for all cycles except slow
cooking
NB: check that the value set is consistent with parameters
from F23 to F45
Minimum fan speed that can be set for slow cooking
NB: check that the value set is consistent with parameters
from F23 to F45
evaporator fan speed 1 with E16 = 2 (control through inverter)
page 77 of 96