Herunterladen Diese Seite drucken

Scheppach IXES AERO2 SPADE Originalbetriebsanleitung Seite 28

Druckluftuniversalwerkzeug
Vorschau ausblenden Andere Handbücher für IXES AERO2 SPADE:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
18. Disposal and recycling
Notes for packaging
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
19. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your product failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Compressed air device
does not start or lacks
power
Tool attachment no longer
latches into the tool
receiver or does not lock
into place
Tool attachment cannot be
inserted or removed
Device operates continu-
ously without the trigger
lever being actuated
28 | GB
Possible cause
Piston jammed (rusted) in the
housing due to a lack of oil
Dirt has penetrated via the air
hose
Too much lubricating oil used or
water in the striking mechanism
Pressing force too high
Output power of the air source
too low
Tool or tool receiver worn out.
(Most often caused by excessive
pressure or no-load strokes)
Dirt in the sliding sleeve prevents
unlocking
Valve defective
www.scheppach.com
You can find out how to dispose of the disused
device from your local authority or city adminis-
tration.
Fuels and oils
• Before disposing of the device, the fuel tank and the
motor oil tank must be emptied!
• Fuel and engine oil do not belong in household
waste or drains, but must be collected or disposed
of separately!
• Empty oil and fuel tanks must be disposed of in an
environmentally friendly manner.
Remedy
• Press the piston back with a striking bolt
through the tool receiver
• Introduce a little oil into the connection
hose and into the tool receiver
• Run the device briefly without a tool
• Repeat this process a few times
Repair must be carried out by a specialist
workshop
Run the device briefly without a tool
Grease tool receiver and reduce pressing
force
Use an air source with a higher output power
Repair must be carried out by a specialist
workshop
Repair/cleaning must be carried out by a spe-
cialist workshop
Repair must be carried out by a specialist
workshop

Werbung

loading