Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Excessive oil damps the impact performance. Drops
are forming on the trigger lever or on the tool receiver.
In this case, reduce the oil quantity on the oiler and
clean the device if necessary. Inadequate oil will result
in damage to the device and tool. Check oil feed and
top up oil or adjust oiler if required.
13. Work complete
Interrupt the compressed air supply from the com-
pressed air hose to the device.
With breaks in work:
• Place the compressed air device safely to one side.
• If there are sharp or pointed tools in the device,
cover these up.
At the end of work:
• Interrupt the compressed air supply.
• Remove the tool from the device.
• Check that the tool receiver has been furnished with
an oil film.
• If this is not the case, introduce a few drops of spe-
cial oil into the connection hose and operate the
device without tool for ca. 15 seconds.
• Clean the compressed air device, the tools, the
hose and any other accessories with a dry or oily,
clean cloth.
14. Cleaning
Danger!
Pull out the battery before carrying out any cleaning
work.
• Keep the product as free of dust and dirt as possible.
Rub the product clean with a clean cloth or blow it off
with compressed air at low pressure.
• We recommend that you clean the product directly
after every use.
• Clean the product at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the product.
15. Storage
Store the product and its accessories in a dark, dry and
frost-free place that is inaccessible to children.
The optimum storage temperature lies between 5 and
30 ˚C.
Store the product in its original packaging. Cover the
product to protect it from dust or moisture. Store the
operating manual with the product.
16. Maintenance
The product is maintenance-free if it is regularly sup-
plied with oil.
17. Repair & ordering spare parts
After repairs or maintenance, make sure that all safe-
ty-related parts are installed and are in perfect con-
dition. All parts which may cause injury must be kept
where they are inaccessible to children or others.
Attention: According to the German Product Liability
Act, no liability is accepted for damage caused by im-
proper repairs or by not using original spare parts.
Such work should be performed by a customer service
centre or an authorised specialist. The same applies to
accessory parts.
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
Important note in the case of repairs:
For return delivery of the product for repair, please en-
sure for safety reasons that it is free of oil and fuel when
it is sent to the service centre.
17.1 Ordering spare parts
Please provide the following information when order-
ing spare parts:
• Model designation
• Item number
• Type plate data
17.2 Service information
With this product, it is necessary to note that the fol-
lowing parts are subject to natural or usage-related
wear, or that the following parts are required as con-
sumables.
Wearing parts*: Tool attachments
* may not be included in the scope of delivery!
www.scheppach.com
GB | 27
Werbung
