Scheppach SC32 Originalbetriebsanleitung Seite 28

• Waste electrical and electronic equipment can be
handed in free of charge at the following places:
- Public disposal or collection points (e.g. municipal
works yards)
- Points of sale of electrical appliances (stationary
and online), provided that dealers are obliged to
take them back or offer to do so voluntarily.
- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
12. Troubleshooting guide
Fault
Motor does not start
Engine performance drops • Soil is too firm
Imprecise scarifying result • Roller worn
Motor is running, roller is
not rotating
28 | GB
Possible causes
• No electricity in plug
• Cable defective
• Switch, switch/plug
block defective
• Connections to motor
or capacitor discon-
nected
• Housing clogged
• Housing clogged
• Roller badly worn
• Wrong working depth
• Toothed belt is torn
www.scheppach.com
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
Rectification
• Check line and fuse
• Have machine checked by a customer service
center
• Have machine checked by a customer service
center
• Have machine checked by a customer service
center
• If necessary adjust working depth. Clean housing
so that the roller can run freely
• Change working depth
• Clean housing
• Replace roller
• Replace roller
• Correct working depth
• By customer service workshop