Mark PinTherm Infra Connect Technisches Handbuch Seite 14

5.19 Control PinTherm Infra Connect via Ethernet
After setting the IP address, it is possible to remotely control and change the PinTherm Infra Con-
nect via the web browser on your mobile phone, tablet or laptop / PC. To do this, enter your set
IP address in the address bar of the browser. Then log in with the following information:
Username: pintherm
Password: 1000
Setting or changing the parameters is possible in the web browser.
For control via the Cloud (IoT/WiFi) see chapter 6.
5.20 Switch overtime timer on/off
This function provides the option of manually switching to the daytime temperature outside the
set switching times for a period of 1, 2 or 3 hours.
The yellow LED with the symbol
right of the display shows the time in minutes that still remains before the function is deactivated
and the PinTherm Infra Connect returns to night temperature control. The function can also be
switched off prematurely by pressing the push-button again until the yellow LED extinguishes and
MON
MON
the number of remaining minutes disappears from the display.
See the illustration below.
5.21 Restore factory settings PinTherm Infra Connect
OK
keep pressed or
+/- 12 secs
All the factory settings are restored when you activate this function. This function may be
activated at any time. See the illustration below.
14
is lit when this function is active. In addition, the bottom
17:01 18°C
NIGHT
17:01 18°C
DAY
X:120
RESET TO DEFAULT
SETTINGS?
This will return you to the
ESC
screen from which you
selected this function and
default settings will not be
restored.
MON 17:01
DAY X:060
MON 17:01
DAY
X:180
DEFAULT SETTINGS
RESTORED!
OK
SELECT LANGUAGE
ENGLISH
MON 08:01
DAY
18°C
18°C
16°C