Endress+Hauser alpha-log Betriebsanleitung Seite 53

120 Paper length
121 Unit identifier
122 Security release
code
123 Fault function onto
2
relay 1
124 Operating
language
125 Temperature units Degrees Celsius (°C) / Degrees Fahrenheit (°F)
130 Peak value
5
recording
131 Time offset
compensation
132 Time printout
133 Channel
information
1
printout
1
140 Date
1
141 Time
142 Normal / summer
time change
1
mode
3 Installation/connection/settting up
Length of paper used (important so that the
remaining paper can be displayed during operation).
1
10 characters
4 digit, works setting: 0000, this means changes
possible without security code.
Set individual code in numbers: Further setting up
changes are only possible after entering this code.
Tip: Note the code and store out of reach from
unauthorised personnel
Switches on error function (fault) and / or paper end.
Dependent on unit type:
German - English - French - Dutch, or
Danish - Swedish - German - English, or
Italian - French - German - English or,
Spanish - US-English - German - French
Switched off: The dot trace shows the measured
value at the time of the plot.
Switched on: The plot shows signal variations that
occurred between plotted dots. ("Envelope curve")
Switched on: The pen at the innermost position
4
traces the incoming signal instantaneously. The
other pens only trace their respective signals (stored
in an intermediate memory) when the corresponding
time is in line with the pen tip.
Advantage: The documentation is in real time and
therefore easily read.
Switched off: All pens react instantaneously to their
respective incoming signal changes.
Advantage: Fast recognition of sequences on
dependency between signals.
1
Switched on: Cyclic printout every 6 cm
Switched on: Cyclic printout every 6 cm.
Channel number, channel identifier,
channel instantaneous value, channel zoom area
Actual date (DD.MM.YY)
Actual time (hh:mm), 24 h clock (military)
Off: No summer / normal time changeover, settings
in addresses Pos. 143 / 144 are ignored
Automatic: Changeover to valid EU
recommendations, display in addresses 143 / 144
Manual: Changeover times set up in addresses
143 / 144
51