Endress+Hauser alpha-log Betriebsanleitung Seite 52

3 Installation/connection/setting up
3.10 Unit settings / operating parameters
Individual unit settings are combined in various chapters according to the
subject matter. Here they are allocated to a position on a grid or matrix (lines
and columns). Only those lines or columns available for the recorder type and
model to be operated are visible and settable.
Chapter
1. Basic settings
2. Channel
parameters
3
3. Limit settings
1
4. Event text
2
5. Digital I/O
6. Service
1
Available only with "Alphanumeric" option"
2
Available only with "Digital I/O" option""
3
Available only with "Alphanumeric" and/or "Digital I/O" option
Standard d110
120mm/h
3.10.1 Basic unit settings: Basic settings
110 Standard paper
feed rate
111 Limit paper
1
feed rate
112 External paper
2
feed rate
1
Available only with "Alphanumeric" option
2
Available only with "Digital I/O" option
50
Settings
= General settings for all channels
(eg. language, paper feed rate, date/time etc.)
= Measurement point specific settings
(eg. measurement point identifier, input signal ...)
= Setting limit set points and their function
= Presettable text, to be printed on limit infringement
and/or by external control inputs
= Preset the control inputs and outputs
= Unit calibration / test functions
The top right corner of the
display shows a three digit
110
"Address number".
First digit:
Second digit: Line (eg. Channel)
Third digit:
Normal paper speed
Paper speed on limit infringement, always faster
than the standard.
To activate see "3 Limit settings"
Paper speed change due to control input allocated
in address 534. The external paper feed rate is
active as long as the input is active.
Chapter number
(eg. 1xx = Basic settings)
Column (eg. Function).