Profitec DRIVE Bedienungsanleitung Seite 150

2. Clean the portafilter and filter with warm water, a food-safe washing-up
liquid, and a soft cloth.
3. Allow the filter and portafilter to dry completely.
4. Install the filter in the portafilter (see Chapter 9.7, „Inserting the filters in
the portafilter").
11.2 Cleaning the drip tray, grid, and cup raiser

CAUTION
Risk of injury due to sharp edges
The edges of the drip tray, grid, and cup raiser are sharp and may cause
injuries.
• Avoid pressing too hard on the edges.
• Wipe over the edges carefully.
Empty the drip tray in good time. Do not wait until it is full to the brim.
Clean the drip tray, grid, and cup raiser daily. Do not put them in the dishwasher.
1. Take the cup raiser off of the grid.
2. Pull the drip tray forwards out of the machine. Remove the grid from the
drip tray.
3. Empty the drip tray over a sink.
4. Clean all parts with warm water, a food-safe washing-up liquid, and a
soft cloth.
5. Allow all parts to dry fully.
6. Install all parts in reverse order.
11.3 Cleaning the steam and hot water nozzles

WARNING
Risk of injury
There is a risk of injury when cleaning the steam and hot water nozzles due
to high temperatures.
• Do not touch the steam wand, steam nozzle, hot water wand, or hot
water nozzle. Only touch them via the rubber handles.
11.3.1 Cleaning the steam and hot water nozzles after use
Clean the steam nozzle and hot water nozzle immediately after every use so
that liquid residues can be removed and do not dry on.
1. Hold the steam nozzle and hot water nozzle by the rubber handle.
2. Wipe the nozzles with a moistened microfiber cloth.
DRIVE_BA_V2.0 EN - 149