Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ECO mode can be ended as follows:
•
Briefly press the left-hand
display is switched on and the machine starts to heat up.
•
Actuate the brew lever (see Chapter 5.2.3, „Operating levers").
•
Program an automatic switch-on time (see Chapter 10.4.3, „Schedule
Set").
9.2
Putting the machine into operation
9.2.1
Switching the machine on and off
Switching on the machine:
1.
Press the on/off button.
The LED ring lights up and the following information appears on the
9
display one after the other:
•
The welcome message "MAKE COFFEE YOURS"
•
The software version
•
The quantity of liters used so far, if the filter reminder is set (see
Chapter 10.4.1, „Filter Reminder")
•
The brew temperature and, if activated, the steam temperature.
Switching off the machine:
1.
Press the on/off button.
The LED ring goes out and the display is switched off.
9
9.2.2 Machine in tank mode
1.
Fill the water tank with water (see Chapter 9.5, „Filling the water
tank with water") and insert it into the machine (see Chapter 11.5.1,
„Orientation of the water tank").
2.
Switch on the machine using the on/off button.
The LED ring lights up.
¾
3.
If the "Flush" icon appears on the display, perform a flush (see Chapter
9.9, „Perform a flush").
The machine heats up. If the setting "Fast Heating" is activated (see
9
Chapter 10.4.8, „Enable Fast Heating"), the heat-up time is approx. 12-
13 minutes. The machine has finished heating up when the temperature
set via the menu (see Chapter 10.3.1, „Brew Temperature") appears on
the display.
EN - 120
or right-hand
navigation button. The
DRIVE_BA_V2.0
Werbung
