Profitec DRIVE Bedienungsanleitung Seite 130

To be able to draw hot water, the steam boiler must be activated (see Chapter
9.4.3, „Switching the steam boiler on or off") and the set steam temperature
(see Chapter 10.3.3, „Steam Temp") must have been reached.
1. Place a suitable receptacle with a heat-insulated handle (e.g. jug or cup)
under the hot water wand.
2. Open the hot water tilt valve (see Chapter 5.2.3, „Operating levers"),
3. After drawing the desired quantity, close the tilt valve.
The valve is closed and the boiler is automatically filled with water.
¾
4. Clean the hot water nozzle (see Chapter 11.3, „Cleaning the steam and
hot water nozzles").
Tip: To draw hot water for several cups one after the other, it is recommended
that you switch off the heated-up machine so that no cold water is pumped
back into the boiler.
9.13 Drawing hot steam

WARNING
Risk of injury due to hot surfaces and hot media spraying out
Injuries may occur when drawing steam due to the high temperatures of the
surfaces and media spraying out.
• Only operate the steam wand via the rubber handle.
• Place a suitable receptacle underneath the steam nozzle when draining
condensation.
• Always keep the nozzle of the steam wand fully under the surface of the
liquid to be heated or foamed when drawing steam.
• Keep your face, hands, and other body parts away from the steam
nozzle.
The machine can generate steam to heat or foam liquids, for example milk or
mulled wine.
To be able to draw hot steam, the steam boiler must be activated (see Chapter
9.3, „Opening and closing the shut-off valve") and the set steam temperature
(see Chapter 10.3.3, „Steam Temp") must have been reached.
1. Place an empty receptacle under the steam nozzle.
2. Open the steam tilt valve (see Chapter 5.2.3, „Operating levers").
Condensation is drained.
¾
3. Close the steam tilt valve after approx. 3 seconds, when no more
condensation comes out.
4. Place the receptacle with the desired liquid under the steam nozzle.
5. Immerse the steam nozzle fully under the surface of the liquid.
6. Open the steam tilt valve.
DRIVE_BA_V2.0 EN - 129