Maintenance; General Information; Battery Replacement; Cleaning The Instrument - HT Instruments HT6 Bedienungsanleitung

6. MAINTENANCE

6.1.

GENERAL INFORMATION

1. While using and storing the instrument, carefully observe the recommendations listed
in this manual in order to prevent possible damage or danger during use.
2. Do not use the instrument in environments with high humidity levels or high
temperatures. Do not expose to direct sunlight.
3. In case the instrument is not to be used for a long time, remove the batteries to avoid
liquid leaks that could damage the instruments internal circuits.
6.2.

BATTERY REPLACEMENT

Only expert and trained technicians should perform this operation. Before
carrying out this operation, make sure that the instrument has been
disconnected from all circuits.
1. Loosen the battery cover fastening screws and remove the cover.
2. Remove the flat batteries from the battery compartment.
3. Insert the new batteries of the same type. Pay attention to the correct polarity.
4. Position the battery cover back over the compartment and fasten it with the relevant
screws.
5. Do not scatter old batteries into the environment. Use the relevant containers for
disposal.
6.3.

CLEANING THE INSTRUMENT

Use a soft and dry cloth to clean the instrument. Never use wet cloths, solvents, water, etc.
6.4.

END OF LIFE

CAUTION: the symbol on the instrument indicates that the appliance and its
accessories must be collected separately and correctly disposed of.
CAUTION
EN - 12
HT6 - HT8 - HT9