HT Instruments HT6 Bedienungsanleitung Seite 25

4.2. SWITCHING ON
The instruments automatically switch on in the following cases:
• Continuity is detected
• AC or DC voltage higher than 10V is detected
• Live phase is connected to L2 lead
• Torch button is pressed
• ON/Reset button is pressed (HT6, HT8)
• Lamp test button is pressed (HT9)
4.3. AUTO POWER OFF
The following conditions are possible:
• The instruments automatically switch off if no signal is detected in contact with leads for
5 seconds
• The torch light turns off after 10 seconds after the torch button has been released
• The lamp test is stopped and the instrument switches off after 5 seconds when the
Lamp test button is released.
EN - 6
HT6 - HT8 - HT9